Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

The image shows the overall workflow of Generative Design including the steps to verify a result..generative design can be devided into the 7 steps:

...

A Design always starts with the preparation of the geometry Geometry Preparation. This step can be donen done either in a CAD program or directly in MSC Apex Generative Design.

In a the next step Geometry & Boundary Conditions the prepared geometry will be is modified to become part of the optimization contain the defined spaces of an optimization model. Furthermore the loads and fixations are applied to the model. This happens in the “Model Tab” of MSC Apex Generative Design. The Nondesign spaces are created and defined in this step as well as all the static boundary conditions. Afterwards the lat

Then the last step of the model preparation can take place. The boundary conditions are assigned to events Events (load cases)and the optimization parameters are defined. After teh the set-up is complete, the optimization Optimization can be carried out.

Once an optimization is started you are directly transferred to the Post Processing in MSC Apex Generative Design and you can track the progress of your optimization in a live view. The post processing gives information about the stresses, displacements and mass of each iteration.

After the optimization is done and the result satisfies all the predefined goals an intersection Intersection needs to be done in order for the part to be firstly ready for manufacturing and secondly used in a reanalysis Reanalysis.