This section encloses Frequently Asked Questions with the corresponding answers, action steps and reference to further information inside this help website.
Topics
- Where can I find Warnings and Errors?
- How to install the GPU Service manually?
- How can I apply a pressure load on multiple connected surfaces?
- Is it possible to fixate rotational DOF?
- Why are my loads not visible in the Studies Tab?
- Why are some geometries not considered in the optimisation?
- Why are my Non-Design Spaces reduced?
- Why is my Machining Allowance not connected to each other?
- Why does the generation of the Design Space STL-file fail?
- How can I find a suitable value for the Safety Factor?
- What does the function Complexity do?
- How do I change the element size (higher resolution)?
- Why can't I start an optimisation with a higher complexity value?
- What is the function CPU Threads for?
- How to optimise on graphics card (GPUs)?
- Is my GPU solver working?
- Why is my calculation running on CPU instead of GPU?
- How do I start an optimisation remotely?
- Why are my stresses higher than the optimisation stress goal?
- Why isn't the mesh of a symmetric optimisation symmetrical?
- Why is my output (timestamp) not readable in the command line optimisation?
- Why does my result of an anisotropic material optimisation look implausible?
- Why does the GPU Solver Engine stop on Windows 11?
- Why are forces missing after updating an older model?
- Why can't I open my model? (Cannot open model with a newer version number)
0 Comments