...
In this case four forces and one moment are defined. The first two are applied on the retained volume and the last three on the Non-Design Space that is connected to the sensor:
Name | Force/Moment/Pressure/Gravity | Direction | Value in N; Nmm |
|---|---|---|---|
Force - Moment 1 | Force on Retained Volume | Fy; Fz | -1000; 1000 |
Force - Moment 2 | Force on Retained Volume | Fx; Fy; Fz | 600; -800; -200 |
Force - Moment 3 | Force on Non-Design Space | Fy | -500 |
Force - Moment 4 | Force on Non-Design Space | Fx; Fy; Fz | 150; -200; -100 |
Force - Moment 5 | Moment on Non-Design Space | Mz | -2000 |
...
Three constraints are created and attached on the Non-Design Spaces on the lower side:
Name | Direction |
|---|---|
Constraint 1 | x, y, z (=0) |
Constraint 2 | x, y, z (=0) |
Constraint 3 | x, y, z (=0) |
...
Step 4: Definition of load cases
...
You can always change the Strut Density, Stress Goal and Complexityto influence the results and try out different options
The Complexitycan be increased for a higher resolution and more detailed result (increased calculation time!)
The Strut Densityinfluences the structures which are formed during optimisation
The whole MSC Apex Generative Design project with all results can be downloaded here:
| View file | ||
|---|---|---|
|
You might also be interested in these tutorials:
...