...
Draft is the tapering angle for walls/ribs regarding the Draw Directions. Specified in degree.
...
Tips & Tricks
| Info |
|---|
Influence the tool length for a speed up. A loss of surface quality (staircase effect) & less defined pockets can be the trade off. |
tool.tool0.lengthFactor=0.5 tool.tool1.lengthFactor=0.5 | For each draw direction (tool) the length factor can be adjusted. The default is 1. By decreasing the value the optimisation will speed up. Suitable values between 0.2 - 1. |
You might also be interested in this tutorial:
...