...
The Start Space STL-file needs to be entered into the optimisation in the same unit system the model is in!
Start Space STL-file
The Start Space for a Restart must be a STL-file. Therefore, an already optimised geometry can be exported in the Post Processing. In this case iteration 22 from the Bookshelf Tutorial will be used.
...
Attention: The STL-file for the Restart should be exported in SI-Unit system (meters) to fit the unit system the optimisation will run with.
Optimisation Setup
In the next step a new Scenario should be created for the Restart optimisation. Therefore, the already existing Scenario can be cloned.
...
You can check the status of the optimisation in the GD Status and get more information on Warning and Error messages. This can be done directly in the Post-Processing as well as in the Studies tab for an optimisation that has already run.
...
The whole MSC Apex Generative Design project with all results can be downloaded here: Coming Soon!