The optimization optimisation calculates the approximated von Mises stress and shows these stress values in the postprocessingpost processing.
...
The eleceted elected stress goal is the overall optimization optimisation goal for each optimization the optimisation and has a big influence on the resulting design. The target is that the material of the part is evenly loaded and the stress is uniformly distributed. Thus, the stress goal isn’t the maximum stress , which can occur at design space limits or due to FE singularities, but the value which is a good middle value for a long part life. Not in every case the yield strength of the material is the best value for this parameter, e.g. when the applied loads are too small to create these result in such stresses. By changing the stress goal, the stiffness of the structure can be influenced as well. Due to uniformly distributed stresses, lower stress goals resulting result in stiffer parts at the most lightweight design. A safety factor can be introduced by considering this factor in the Stress Goal value. The user needs to take into account if a safety factor is needed and adjust the Stress Goal accordingly.
The used stress goal is dependent on the resolution levelslevel during the optimisation. The optimization optimisation runs on different resolution levels and switches between them to achieve the best results. The first iterations are calculated on a coarse resolution level. With rising number of iterations, the resolution gets finer. This means that the first iterations calculate much faster than the last iterations but aren’t as detailed as the last. With the increasing resolution, the size of the output data, the calculation time as well as the surface quality increase.
For each resolution level a different stress percent goal is defined which is dependent on the stress goal set for the optimizationoptimisation. On the lower resolution levels the stress goal varies on purpose from the requested stress goal to realize a fast design generation. On the highest resolution level, the requested stress goal reaches 100% and thus satisfies the defined stress goal as the geometry allows it.
In one optimization optimisation several Events (load cases) can be considered. Each Event is calculated by itself and the stresses of all Events are superimposed (overlaid)enveloped and the highest stress for each area is considered.
The stress calculation is from an FE point of view an estimation. That’s why we recommend a FE reanalysis using Apex Structures/Nastran to verify the results regarding all boundary conditions. For the reanlysis reanalysis the intersected model should be used which will be manufactured and used. The reanalysis can also take dynamic loading & other boundary conditions into consideration that are not considered in the design process. For more information regarding intersection have a look here.
For further information regarding the stresses in the Post Processing, have a look here.