Page Comparison

...

• Create the material Titanium in the Materials editor and assign it to the Design Space. In this case the material behaviour is Isotropic.

• The specific values needed are the Young's Modulus (116e3 MPa), Poisson ratio (0.26) and Density (4.48e-6 kg/mm³).

• The Tension Strength is the maximum allowable stress for the material and is set to 1290 MPa.

...

You might also be interested in these tutorials:

• Generative Design - Bookshelf

• NURBS Retransition Full Workflow - Jet Engine Bracket

• Anisotropic Material Behaviour & the influence of different Failure Criteria - Hook

• Generative Design - Command Line Optimisation

• Support Reduction - Gripper