This tutorial shows how to perform a Restart and carry out a Two-stage optimization which can be used for different applicationsof a stopped optimisation. Therefore, the Advanced User Settings are needed. More information regarding the background of a Restart here.
With this option a terminated optimization optimisation can be continued or a two-stage optimization with modified optimization parameters can be done. To realize a Restart or Two-stage optimization instead of the Design spaceanother geometry can be chosen as the Start space. In this case the optimization optimisation starts with the specified geometry although the whole Design space is still the geometry limitation for the optimizationoptimisation.
...
The Start space STL-file needs to be entered into the optimisation in S.I. units!
Start Space STL-file
The Start space for a Restart must be a STL-file. Therefore, a already optimized optimised geometry can be exported in the Post Processing. In this case iteration 22 from the Bookshelf Tutorial will be used.
...
Attention: The STL-file for the Restart must be exported in SI-Units (Meters).
...
...
optimisation Setup
In the next step a new scenario Scenario should be created for the Restart optimisation. With the Advanced User Settings- available through a right click on the Scenario - the Start space STL-file can be selected. In this case the exported iteration 22 from an former optimization is selected. Furthermore, the symmetry constraints from the first optimization are added.
The most important part of a Restart is to add and adjust the Advanced User Setting Settings especially the number of iterations, the resolution level and the stress goal percentage. More background information regarding the Advanced User Settings here.
...
This can be done when an optimization is terminated and restarted at another time. In this example the Bridge Bookshelf should be restarted as if the optimization optimisation never stopped, so with the same optimization optimisation parameters as the first optimization optimisation excluding the already done iterations. Therefore, the settings for the parameters Strut Density: Medium and Shape Quality: Balanced are added to the Advanced User Settings and adjusted according to the numer number of iterations already calculated. Which number of iterations and which stress percent goal should be input for each resolution level can be found here.
In this case the optimization will restart at iteration 22, thus 42 iterations must be added to reach the total number of 64 iterations (Shape Quality: Balanced).
Resolution level | Iteration | Stress Percent Goal |
|---|---|---|
.level_2 | 18 | 40 |
.level_1 | 20 | 90 |
.level_0 | 4 | 100 |
...
The information are added in the Advanced User Settingsin the following style:
UpSampleConfig
...
.level_2=40
.level_2=90
.level_2=100
The command fOptimizer_switchAddRemove needs to be active for the last 4-10 iterations for the quality of the surface smoothness, so in this case 42-6=36.
After adding these commands to the Advanced User Settings the optimization optimisation can be started. The first iteration of the restarted optimization optimisation will be the imported Start space.
Two-stage optimization
A second possibility is to perform a two-stage optimization. Instead of a simple restart with the same optimization parameters the parameters can be varied.
Examples:
...
Skipping the coarse resolution level and calculate directly on the finest resolution level with an early iteration from a former optimization, if a very fine high-resolution level is desired
...
Vary the value for the stress goal to keep the overall geometry with more or less material
...
Modify an optimization output (remove or add struts) and restart with this modified geometry
...