| Info |
|---|
Goal of this tutorial
|
Training:
Relevant data for this tutorial:
...
In this case one force is defined (on the top plate volume):
Name | Force/Moment/Pressure/Gravity | Direction | Value in N |
|---|---|---|---|
Force - Moment 1 | Force on surface | y | -4000 |
...
One constraint on the foot is created and attached on the Non-Design Space:
Name | Direction |
|---|---|
Constraint 1 | x, y, z (=0) |
...
Step 4: Interface Creation
...
Manufacturing Method: Generic AM
Failure Criteria: Von Mises
Safety Factor: 6 .4 (Stress Goal: 50 53,33 MPa)
You can switch between the Safety Factor and Stress Goal in the properties panel by clicking the gear wheel.Strut Density: Medium
Shape Quality: Balanced
...
All result iterations are displayed as soon as they are available. Furthermore, you are able to stop the optimisation in this selection area. However, a Restart is not directly possible.
...
The legend can be influenced in different ways. You can add and reduce the stress/displacement steps, enlarge different steps and set new minimum and maximum values. The picture below shows the stress distributionwith a scale spectrum from 0 to 2 times the stress goal, which is a good fit for all optimisations. This displays the even distribution of the selected stress goal with the colour range of green and critical points are viewable in red.
...
You can go back to the model setup by clicking the Exit button in the right bottom corner.
...
| View file | ||
|---|---|---|
|
You might also be interested in these tutorials:
...