To use the interface you don't need to install anything but start the solver als follows (for Windows: use a Powershell):
CudaPCGSolverDouble_cuda_10-1_gcc_4-8-5 1234
...
- mscgd2019_CUDASolver 1234
- The IP and port must be specified in the configuration file "FEM" (Standard "localhost" and "1234")
...
- .
- The solver can be used by several optimizations and doesn't have to be started again for following optimizations.
- If the solver is not active, the error message "Cannot connect to Extern Solver, use CG solver" will appear in the Log file.