...
Please contact the support
W1c3ad048
The optimization removed more than 95% of the possible volume, which can lead to unclear geometries. Consider reducing the stress target.
A lot of material was removed. In most cases this is not the desired behaviour. The stress target could be chosen incorrectly.
W1c3ad049
The optimization removed less than 10% of the possible volume, which can lead to a longer calculation time and indicates that the optimization does not have enough space to find the best geometry. Consider increasing the stress target or design space.
W4c6bbd7f
Configured both TOPVAR STRESS and EMENPRM SF - ignoring the latter
A stress value is defined in the TOPVAR card as well as a safety factor in the EMENPRM card. The TOPVAR stress value will be considered.
W4d647e01
not optimizing for casting - ignoring EMENPRM CASTPRM
CASTPRM can only be used for a casting optimization.
W52c8c658
Ambiguous tensile strength - MAT1 ST field set for solid … overridden by TOPVAR STRESS
A material stress limit is defined as well as a TOPVAR Stress value. The TOPVAR Stress value is considered.
W5e13e145
sfMesher failed to terminate properly
The sfMesher creates automatically the volume mesh for the MSC Nastran re-analysis. In this case sfMesher failed. Please contact the support.
E0ab33147
tool region … refers to non-volumetric geometry
...