Page Comparison

Influencing the number of iterations & the Strut Density

To influence the optimisation parameterseven further, changes of the number of iterations and number of resolution levels can be made. These settings overwrite the selection of the Strut Densityand the Shape Quality as they are only default settings for the ones described here. The table gives an overview of the default settings:

General Optimisation without a manufacturing method:

Optimisation with casting manufacturing method:

The software uses five resolution levels from coarse to fine (level 1: coarse - level 5: fine). The number behind the level indicates the number of iterations calculated on this resolution level. To remove or skip a resolution level the value can be set to 0.

To set up these additional parameters, the Input Commands (left side of the table) need to be added to the optimisation model in the Advanced User Settings text field. In the picture below an example is shown. By adding these Advanced User Settings, the first (coarse) resolution level will be skipped and the optimisation starts directly at the second level. You might want to add more iterations to the remaining levels to give the optimisation the chance to reduce the material accordingly and reach a convergence in each level.

...

For a general optimisation without a manufacturing method the difference between the Strut Densities is done by an internal geometry smoothing of the elements in the background. Depending on the intensity of the smoothing more, smaller struts (dense) or less, thicker struts (sparse) can be created for the same model & boundary conditions.

For an optimisation with casting as the manufacturing method the difference between the Strut Densities is done by different relative stress target per resolution level.

Restart (Start Space)

With the Advanced User Settings a Restart is possible. A Start Space needs to be chosen with which the optimisation will re/start.

...