...
Minimum thickness of a rib/wall and all other resulting shapes. Specified in world units.
Maximum Wall Thickness
With the Advanced User Settings a maximum wall/rib thickness can be set up.
Casting Region
A Casting Region can be added to the Casting Manufacturing Method. A Casting Region defines casting specific settings for separate regions of the Design Space.
If Casting Regions are used, please make sure that all areas of the Design Space are covered. If a Main Draw Direction is also specified, there is automatically one additional region covering the whole Design Space.
...
Target Stress (In-Plane directions) | 20 MPa |
Scale Target Stress in build direction | 0.8 |
Target Stress in build direction | 16 MPa |
Support Reduction
The Support Redcution function is not available in this add-in version. The function will return shortly redesigned and improved.The Support Reduction function reduces the needed support structure for the optimized part in regard to the Build Plane. The target is to reduce the amount of needed support for overhang angles of 45° while maintaining nearly the same mechanical performance as designs without manufacturing constraints.
The overhang angle can be modified with the Advanced User Settings.
Strategy
Three different strategies are available:
PassiveLowReactiveMediumActiveHigh
The influence of the Support Reduction on the design increases from Passive Low to Reactive Medium to Active High.
...
This comparison shows the influence of the three different Support Reduction strategies regarding the resulting mass, the maximum deflection and the needed support volume compared to a base design without any support strategy.
...
Intensity
For the strategies Reactive and Active a second value can be defined, the Intensity. The Intensity can be set between 1 and 10, where 1 is very low and 10 is very high. Take in mind that a very high Intensity could lead to a slower performance and unusual results.The influence of the strategies is highly dependent on the model.
...
Hints
If a Build Plane is added, this Build Plane will act as the Working Coordinate System for the optimization. Symmetry can only be used with reference to the Build Plane and therefore the defined Working Coordinate System.
It is recommended to start with the firstSupport Reductionstrategy (Passive) and use the other two together with theIntensityif the results are not satisfying.Use theShape QualityFine Tuneto get better results and get rid of artifacts that can occur during theSupport Reduction.