...
event.Event2.frequencyMax=4500 |
If the Frequency Constraint is higher than the first calculated Eigenfrequency of the whole Design Space in the first Iteration, this can lead to the case that no material will be reduced. This can be resolved by reducing the Frequency Constraint or by entering the following command to the Advanced User Settings:
schedule.iterations.~.operator.optloop_loop_analysis_Event-2_extractLocalFailures.useMetricGoalFactor=1 |
It has been found that comparable heavy point masses can cause that the optimisation does not achieve the Frequency Constraint. To address this the impact value can be set up to a value greater than 1. This can be done with the following Advanced User Settings command:
event.Event_2.impact=1.5 |
You might also be interested in these tutorials:
...