...
The build direction is set scenario specific and can be easily changed. for each scneario Thus the PCS also rotates accordingly which influences not only the build direction for the Support Reduction but also the material orientation (Anisotropic Material Stiffness) and directional dependent Stress Goals.
...
You can check the status of the optimisation in the GD Status and get more information on Warning and Error messages. This can be done directly in the Post-Processing as well as in the Studies tab for an optimisation that has already been executed.
...
If all data is correct, the optimisation can be started and tracked in the Post Processing. The Analysis Readiness function checks if all information is provided and the optimisation can start.
All result iterations are displayed as soon as they are available. Furthermore, you are able to stop the optimisation in this selection area. However, a Restart is not directly possible.
...
Step 8: Visualization of Failure Criteria, Displacements etc.
Inside the Post Processing the Stresses, Failure Criteria, the Displacements, the Optimisation Achievement index and the volume/mass are visible for all iterations
The Scale can be influenced individually
With the buttons in the bottom bar it is possible to switch between the Nominal-, Print- and Smooth-Geometry. All of them can be exported as an STL-file or transferred directly back to the Pre Processing as an NURBS CAD-Geometry.
...