Training:
Relevant data for this tutorial:
Step 1: Transfer Design Candidate & Map LBCs and Material
For this Tutorial the Jet Engine Bracket project is used.
...
Save the project and close MSC Apex Generative Design.
Step 2: Open Database in MSC Apex
Open the MSC Apex Generative Design database with the transitioned Design Candidate in MSC Apex.
...
The geometry as well as the LBCs and Material information are transferred and available for the verification.
Step 3: Meshing
The optimised geometry needs to be meshed with a tetraeder mesh for the reanalysis. For the Jet Engine Bracket a quadratic element with a mesh size of 3 mm is chosen.
...
Step 4: Assign 3D Element Properties
For the reanalysis in MSC Apex a 3D Element Property needs to be created. The corresponding Material ID with the used material (in this case: Titanium) needs to be selected.
...
Assign the 3D Element Property to your mesh (not to the solid):
...
Step 5: Set up the static scenario
In the studies tab the static analysis scenario can be set up. Therefore, the model representation need to be linked to the optimised geometry. Under Loads & Constraints the Events can be set up.
...