MA check if description is suitable
Void Spaces add Access Region, Clearance Region, Excluded Part
Explain Retained Part
For the optimisation we define different areas of the geometry. These are mainly Design and Non-Design Spaces.
...
The Non-Design Space contains the necessary geometries of the part. Any part for which you need a clearly defined geometry should be a Non-Design Space. To create Non-Design Spaces the geometry needs to be either split into cells or a constraint is applied to a surface, edge or point which automatically creates a Non-Design Space for this geometry. Cells are partitions of the Design Space. They can be created with the split tool, directly in the Non-Design selection tool Tool or with a Boolean operation using two or more solids.
Void Spaces are spaces within your part where no material is allowed to be and free space for example for other parts of the assembly is needed. These spaces need to be cut out of the Design Space with a Boolean operationcan be easily created with the Access Region and Clearance Region Tools. Especially for realising Part Consolidation these Tools assist to prepare the Design Space and the geometry for the optimisation.
Intersections are necessary after each optimisation to get the defined surfaces of the Non-Design Spaces as well as the printing geometry with Machining Allowance. These defined shapes are needed for example for the post processing of the manufacturing process. The intersection is done automatically for every iteration and can be seen in the Post Processing.
To realize a post processing of additive manufactured parts an Manufacturing Machining Allowance needs to be considered for the all functional surfaces. This needs to be added to the Non-Design Spaces and therefore to the Design Space before an optimisation is started. Afterwards it is very complicated and time consuming to add such an offset to the result fileThe Machining Allowance Tool helps to create these offset automatically so that the optimisation directly produces a manufacturable design with offsets as well as the final geometry for the CAD/CAM system.
Tip: Avoidance of stress rising on Design Space boundaries. Sometimes it is useful to reduce the Design Space a little bit for the optimisation by subtracting an offset. The optimisation is carried out with this reduced Design Space. However, the intersection afterwards is done with the originally defined Design Space in order to avoid sharp edges and thus stress risings. This way you avoid stress risings on the boundaries after you have combined your optimisation result with your original Design Space.