...
symmetry.z (X-Y-Plane is symmetry plane)
If the symmetry should relate is to refer to a local coordinate system additionally , the following command has to typed in into must also be entered in the Advanced User Settings:
symmetry.coordinateSystemBase = Coordinate_System_1
...
The symmetry constraint might not show exactly symmetrical designs while choosing the calculation type “Preview”. This is because of the low resolution level but will not occur once the calculation type is set to “Balanced” or “Fine Tune” and the optimisation runs through.
HintTipp: Only a half, a quarter or an eighth of the model will be calculated. Thus, only a half, a quarter or an eighth of the calculating resources are needed.
...