With the Loads & Boundary Condition Tools all Boundary Conditions can be created which are required for the optimisation. It can be chosen between Displacement Constraints and Structural Loads (directly or remotely applied).
...
Constraints can be applied on cells, surfaces, edges and points which automatically become a Nondesign space Non-Design Space. To apply a constraint to a cell, the cell has to be created beforehand. This can be done using the split tool or with a Boolean operation. What cells are, how they are created and defined is mentioned here.
...
All forces and moments can be applied on cells, surfaces, edges and points. Please be aware, that when a boundary condition is applied on a surface/edge/point only this will be automatically a Nondesign spaceNon-Design Space. In most cases a bigger Nondesign space Non-Design Space is needed, which should be created separately or the boundary condition needs to be applied on a cell (volume).
The image below shows that with Nondesign spaces Non-Design Spaces on the left the functional areas that are important for the post processing are completely available. On the right side only the surfaces were used as load/constraint application points and no post processing after additive manufacturing is possible.
...
The acceleration only affects the Design spaceSpace and doesn’t need to be applied on a cell or surface!
Attention: If only an acceleration and no other load is defined in the same load case, the optimisation will get rid of the whole material iterative. The acceleration force is directly dependent on the volume of the Design spaceSpace. As the Design space Space is reduced so is the acceleration force until no material is left.
...